Fitrite 124 2-Pipe Snow Rail Brackets
Mullane Fitrite #124 2-Pipe Bronze or Galvanized Snow Rail Bracket for asphalt shingle roofs.
The FR124 Mini Protector Snow Fence Bracket is available in malleable galvanized iron or cast bronze mounted on a brass plate. The castings are mounted on a 2" x 12" plate with pre-drilled holes for easy installation. The bracket assembly is set up to accommodate two 1/2" I.D. pipes (use galvanized pipes with the iron bracket and brass with the bronze bracket). Brackets are adjustable to the roof pitch. The FR124 should be used only where low to moderate snow loads are anticipated and can be mounted to most any roof surface.
If you want a 2-pipe snow rail bracket for slate roofs, use the Galvanized FR121 or the Bronze FR122. The brackets are sized the same as the slate size.
FR124ML: Galvanized is $96.00
FR124BRZ: Bronze is $183.00
RBPCON800: Berger 1/2" Brass Pipe Coupling are $7.00 each
RBTEC800: Berger 1/2" Brass Pipe End Caps are $7.00 each
Snow rail fence brackets are installed parallel to and approximately 24-36 inches above the eaves. The brackets should be spaced from 18-24 inches to no more than 42-48 inches apart horizontally, depending on the pitch of the roof and the expected snow load. It is recommended to use through bolts with a backer plate on the underside of the roof deck. Bronze, brass, or stainless steel pipe is recommended. Copper water pipes should not be used with Mullane snow rails, although they are used with Sieger snow rail brackets, both for slate roofs and for standing seam roofs.
NOTE: Returned Berger and Mullane snow guards incur a 25% restocking fee.